NEWS INFORMATION

NEWS INFORMATION

The thickener reducer shares the operating procedures of the thickener with you


Release time:

2021-08-26

The thickener reducer shares the operating procedures of the thickener with you

The thickener reducer shares the operating procedures of the thickener with you

1. It must be done before the concentrator starts

1. Remove debris from the upper part of the machine and around, and check that there are no obstacles on the rack and raceway. The transmission part and lubrication parts should be in good condition and not allowed to run with disease.

2. Check whether the mine pipe or trough is unblocked, the rakes are in good condition, the underflow gate should be opened and closed freely, and the cofferdam should be closed tightly (requires a spare gate) without defects.

3. Check whether the rubber pump screws are loose and the triangle belt is tight.

4. Check the condition of the roller screen for sieving particles. Confirm the above four points before driving.

2. For the thickener with lifting device, lift the rake to a certain position before driving, and then drive. Disconnect the rake when stopping suddenly, find out the cause and remove the fault before driving.

Three. Do it in operation

1. Close the underflow gate, drive without load, and then feed to the mine.

2. Sundries are not allowed to fall into the machine, and the bottom discharge gate must be opened flexibly and equipped with a spare gate.

3. Check the operation of the rubber pump in the center of the thickener and the transmission parts. Packing leakage should be dealt with in time, and the lubrication parts should be filled with oil in time.

4. To keep the safety device, the signal is in good condition.

Four. Do it when you stop

1. Before stopping, the tailings must be processed, reduce the load as much as possible, and close the ore gate.

2. Clean up the debris and equipment in the mine passage and hang up warning signs to do a good job in civilized production.